It would be good if you could re-create or re-trace your steps: it would be helpful to others who may follow in your path. Beyond "follow the directions in the manual" I feel a little inadequate though I have gotten the HPT to work with both RH and SuSE. Congrats. Richard On Saturday 09 March 2002 09:03 pm, you wrote: > Well days, hours later... I think I finally got it work. > I'm a little bit surprised cause I really don't know why it works now. > > But the important thing for me is: > It works with smp support enabled. ( opposite mentioned inside the suse > install manual) > > thx > > Thorsten Klingert > > > > > > - > Mar 10 04:40:02 ftp kernel: PIIX4: IDE controller on PCI bus 00 dev 39 > Mar 10 04:40:02 ftp kernel: PIIX4: chipset revision 1 > Mar 10 04:40:02 ftp kernel: PIIX4: not 100%% native mode: will probe > irqs later > Mar 10 04:40:02 ftp kernel: ide0: BM-DMA at 0xf000-0xf007, BIOS > settings: hda:DMA, hdb:DMA > Mar 10 04:40:02 ftp kernel: HPT370A: IDE controller on PCI bus 00 dev 58 > Mar 10 04:40:02 ftp kernel: PCI: Enabling device 00:0b.0 (0005 -> 0007) > Mar 10 04:40:02 ftp kernel: HPT370A: chipset revision 4 > Mar 10 04:40:02 ftp kernel: HPT370A: not 100%% native mode: will probe > irqs later > Mar 10 04:40:02 ftp kernel: ide2: BM-DMA at 0xb800-0xb807, BIOS > settings: hde:DMA, hdf:pio > Mar 10 04:40:02 ftp kernel: ide3: BM-DMA at 0xb808-0xb80f, BIOS > settings: hdg:DMA, hdh:pio > Mar 10 04:40:02 ftp kernel: HPT370A: onboard version of chipset, pin1=1 > pin2=2 > Mar 10 04:40:02 ftp kernel: HPT370A: IDE controller on PCI bus 00 dev 98 > Mar 10 04:40:02 ftp kernel: PCI: Enabling device 00:13.0 (0005 -> 0007) > Mar 10 04:40:02 ftp kernel: HPT370A: chipset revision 1 > Mar 10 04:40:02 ftp kernel: HPT370A: not 100%% native mode: will probe > irqs later > Mar 10 04:40:02 ftp kernel: ide1: BM-DMA at 0xe000-0xe007, BIOS > settings: hdc:pio, hdd:pio > Mar 10 04:40:02 ftp kernel: HPT370A: IDE controller on PCI bus 00 dev 99 > Mar 10 04:40:02 ftp kernel: HPT370A: chipset revision 1 > Mar 10 04:40:02 ftp kernel: HPT370A: not 100%% native mode: will probe > irqs later > Mar 10 04:40:02 ftp kernel: ide4: BM-DMA at 0xec00-0xec07, BIOS > settings: hdi:pio, hdj:pio > Mar 10 04:40:02 ftp kernel: PDC20268: IDE controller on PCI bus 00 dev > 78 > Mar 10 04:40:02 ftp kernel: PDC20268: chipset revision 1 > Mar 10 04:40:02 ftp kernel: PDC20268: not 100%% native mode: will probe > irqs later > Mar 10 04:40:02 ftp kernel: PDC20268: ROM enabled at 0xe9000000 > Mar 10 04:40:02 ftp kernel: PDC20268: (U)DMA Burst Bit ENABLED Primary > MASTER Mode Secondary MASTER Mode. > Mar 10 04:40:02 ftp kernel: ide5: BM-DMA at 0xd000-0xd007, BIOS > settings: hdk:pio, hdl:pio > Mar 10 04:40:02 ftp kernel: ide6: BM-DMA at 0xd008-0xd00f, BIOS > settings: hdm:pio, hdn:pio > Mar 10 04:40:02 ftp kernel: hda: FUJITSU MPB3032ATU, ATA DISK drive > Mar 10 04:40:02 ftp kernel: hdb: WDC WD307AA, ATA DISK drive > Mar 10 04:40:02 ftp kernel: hde: WDC WD800BB-00CAA0, ATA DISK drive > Mar 10 04:40:02 ftp kernel: hdg: WDC WD800BB-00BSA0, ATA DISK drive > Mar 10 04:40:02 ftp kernel: hdk: IBM-DTLA-307015, ATA DISK drive > Mar 10 04:40:02 ftp kernel: hdl: ST360021A, ATA DISK drive > Mar 10 04:40:02 ftp kernel: hdm: IBM-DTLA-307045, ATA DISK drive > Mar 10 04:40:02 ftp kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 > Mar 10 04:40:02 ftp kernel: ide2 at 0xa800-0xa807,0xac02 on irq 15 > Mar 10 04:40:02 ftp kernel: ide3 at 0xb000-0xb007,0xb402 on irq 15 > Mar 10 04:40:02 ftp kernel: ide5 at 0xc000-0xc007,0xc402 on irq 10 > Mar 10 04:40:02 ftp kernel: ide6 at 0xc800-0xc807,0xcc02 on irq 10 > Mar 10 04:40:02 ftp kernel: hda: 6335280 sectors (3244 MB), > CHS=785/128/63, UDMA(33) > Mar 10 04:40:02 ftp kernel: hdb: 60074784 sectors (30758 MB) w/2048KiB > Cache, CHS=59598/16/63, UDMA(33) > Mar 10 04:40:02 ftp kernel: hde: 156301488 sectors (80026 MB) w/2048KiB > Cache, CHS=155061/16/63, UDMA(100) > Mar 10 04:40:02 ftp kernel: hdg: 156301488 sectors (80026 MB) w/2048KiB > Cache, CHS=155061/16/63, UDMA(100) > Mar 10 04:40:02 ftp kernel: hdk: 30003120 sectors (15362 MB) w/1916KiB > Cache, CHS=29765/16/63, UDMA(100) > Mar 10 04:40:02 ftp kernel: hdl: 117231408 sectors (60022 MB) w/2048KiB > Cache, CHS=116301/16/63, UDMA(100) > Mar 10 04:40:02 ftp kernel: hdm: 90069840 sectors (46116 MB) w/1916KiB > Cache, CHS=89355/16/63, UDMA(100) > Mar 10 04:40:02 ftp kernel: Partition check: > Mar 10 04:40:02 ftp kernel: hda: hda1 hda2 hda3 > Mar 10 04:40:02 ftp kernel: hdb: hdb1 > Mar 10 04:40:02 ftp kernel: hde: unknown partition table > Mar 10 04:40:02 ftp kernel: hdg: unknown partition table > Mar 10 04:40:02 ftp kernel: hdk: [PTBL] [1867/255/63] hdk1 > Mar 10 04:40:02 ftp kernel: hdl: [PTBL] [7297/255/63] hdl1 > Mar 10 04:40:02 ftp kernel: hdm: [PTBL] [5606/255/63] hdm1 > Mar 10 04:40:02 ftp kernel: loop: loaded (max 8 devices) > Mar 10 04:40:02 ftp kernel: 8139too Fast Ethernet driver 0.9.24 > Mar 10 04:40:02 ftp kernel: eth0: RealTek RTL8139 Fast Ethernet at > 0xd0809000, 00:50:22:40:4a:6e, IRQ 5 > Mar 10 04:40:02 ftp kernel: eth0: Identified 8139 chip type 'RTL-8139C' > Mar 10 04:40:02 ftp kernel: Linux agpgart interface v0.99 (c) Jeff > Hartmann > Mar 10 04:40:02 ftp kernel: agpgart: Maximum main memory to use for agp > memory: 203M > Mar 10 04:40:02 ftp kernel: agpgart: Detected Intel 440BX chipset > Mar 10 04:40:02 ftp kernel: agpgart: AGP aperture is 64M @ 0xe0000000 > Mar 10 04:40:02 ftp kernel: ataraid/d0: unknown partition table > Mar 10 04:40:02 ftp kernel: Highpoint HPT370 Softwareraid driver for > linux version 0.01 > Mar 10 04:40:02 ftp kernel: Drive 0 is 76319 Mb > Mar 10 04:40:02 ftp kernel: Drive 1 is 76319 Mb > Mar 10 04:40:02 ftp kernel: Raid array consists of 2 drives. > > > > > > > _______________________________________________ > > Ataraid-list@xxxxxxxxxx > https://listman.redhat.com/mailman/listinfo/ataraid-list
