Wayne Lau found my error, in zaptel.conf I made this change... #dchan=16 bchan=16 Thanks! On Fri, Feb 5, 2010 at 9:21 AM, equis software <equissoftware at gmail.com>wrote: > I?m using Digium TE100P (1 E1), I was using this card with PRI signaling > without problems. In fact zaptel.conf didn?t change. > > I think the cable is ok, because when I connect with my provider (UTStarcom > switch) the card led turn to green. > I will test with a loop. > > Thanks > > > On Fri, Feb 5, 2010 at 6:36 AM, Goke M Aruna <goksie at gmail.com> wrote: > >> I will advise you put a physical loop-back cable on the port and confirm >> your configuration is okay and later work with your provider. >> >> >> >> >> On Thu, Feb 4, 2010 at 10:13 PM, Peter Petrov <peterpet at mail.ru> wrote: >> >>> hi, check the physical transport layer. Check the cable, and if you have >>> optical E1 modems check the right configuration of the jumpers! In the past >>> i have the same message and i fix this with right configured jumpers on >>> modems on my side and Telco side. and what kind of E1 card you are use for >>> this SS7? >>> >>> -- >>> _____________________________________________________________________ >>> -- Bandwidth and Colocation Provided by http://www.api-digital.com -- >>> >>> asterisk-ss7 mailing list >>> To UNSUBSCRIBE or update options visit: >>> http://lists.digium.com/mailman/listinfo/asterisk-ss7 >>> >> >> >> -- >> _____________________________________________________________________ >> -- Bandwidth and Colocation Provided by http://www.api-digital.com -- >> >> asterisk-ss7 mailing list >> To UNSUBSCRIBE or update options visit: >> http://lists.digium.com/mailman/listinfo/asterisk-ss7 >> > > -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.digium.com/pipermail/asterisk-ss7/attachments/20100205/51ffe8e0/attachment-0001.htm
|