I?m using Digium TE100P (1 E1), I was using this card with PRI signaling without problems. In fact zaptel.conf didn?t change. I think the cable is ok, because when I connect with my provider (UTStarcom switch) the card led turn to green. I will test with a loop. Thanks On Fri, Feb 5, 2010 at 6:36 AM, Goke M Aruna <goksie at gmail.com> wrote: > I will advise you put a physical loop-back cable on the port and confirm > your configuration is okay and later work with your provider. > > > > > On Thu, Feb 4, 2010 at 10:13 PM, Peter Petrov <peterpet at mail.ru> wrote: > >> hi, check the physical transport layer. Check the cable, and if you have >> optical E1 modems check the right configuration of the jumpers! In the past >> i have the same message and i fix this with right configured jumpers on >> modems on my side and Telco side. and what kind of E1 card you are use for >> this SS7? >> >> -- >> _____________________________________________________________________ >> -- Bandwidth and Colocation Provided by http://www.api-digital.com -- >> >> asterisk-ss7 mailing list >> To UNSUBSCRIBE or update options visit: >> http://lists.digium.com/mailman/listinfo/asterisk-ss7 >> > > > -- > _____________________________________________________________________ > -- Bandwidth and Colocation Provided by http://www.api-digital.com -- > > asterisk-ss7 mailing list > To UNSUBSCRIBE or update options visit: > http://lists.digium.com/mailman/listinfo/asterisk-ss7 > -------------- next part -------------- An HTML attachment was scrubbed... URL: http://lists.digium.com/pipermail/asterisk-ss7/attachments/20100205/01da35b7/attachment.htm
|