2010/3/29 Angel Tsankov <fn42551@xxxxxxxxxxxxxxxx> > Raymond Yau wrote: > > 2010/3/26 Angel Tsankov <fn42551@xxxxxxxxxxxxxxxx> > > > >> Hello again! > >> > >> I've recently had some time to investigate this problem further on and > >> here's what I've discovered: > >> > >> Raymond Yau wrote: > >>> 2010/2/26 Pacho Ramos <pacho@xxxxxxxxxxxxxxxxxxxxxxxxxxx> > >>> > >>>> El vie, 26-02-2010 a las 13:57 +0200, Angel Tsankov escribió: > >>>>> Raymond Yau wrote: > >>>>>> 2010/2/25 Jaroslav Kysela <perex@xxxxxxxx> > >>>>>> > >>>>>>> On Thu, 25 Feb 2010, Angel Tsankov wrote: > >>>>>>> > >>>>>>>> Jaroslav Kysela wrote: > >>>>>>>>> On Thu, 25 Feb 2010, Angel Tsankov wrote: > >>>>>>>>> > >>>>>>>>>> Hello, > >>>>>>>>>> > >>>>>>>>>> I run 'alsactl restore' on a machine with 2 sound cards -- a > >>>> built-in > >>>>>>>>>> Intel Corporation 82801EB/ER (ICH5/ICH5R) AC'97 Audio Controller > >>>> (rev > >>>>>>>>>> 02) and a non-built-in Yamaha Corporation YMF-724F [DS-1 Audio > >>>>>>>>>> Controller] (rev 03) -- and get the following message: > >>>>>>>>>> > >>>>>>>>>> Unknown hardware: "YMF724F" "SigmaTel STAC9700,83,84" > >>>> "AC97a:83847600" > >>>>>>>>>> "0x1073" "0x000d" > >>>>>>>>>> Hardware is initialized using a guess method > >>>>>>>>>> > >>>>>>>>>> As a consequence the volume levels of the Yamaha card do not get > >>>>>>>>>> restored to the levels stored in /etc/asound.state. The volume > >>>> levels > >>>>>>>>>> of the built-in card however are properly restored. The > >>>> asound.state > >>>>>>>>>> file has been created by executing 'alsactl store'. > >>>>>>>>>> > >>> your problem is "alsactl restore" become "alsactl init" when the number > >> of > >>> controls is more than those in state file. > >> I'm not quite sure that the case is this since 'alsactl restore' does > >> restore the values of the Yamaha sound card (and those of the other > >> card, too) and 'alsactl restore 1' seems to just initialize the Yamaha > >> card. This is with alsa-utils version 1.0.22. > >> > > "Hardware is initialized using a guess method " is the message used by > > alsactl init > > > > > http://git.alsa-project.org/?p=alsa-utils.git;a=commitdiff;h=9a748178d1c9e783242f0cc794ab3efb27092f34;hp=0c02a4e3d23c7b5d03215f1bfaba9f70ed11e9b7 > > I don't get what you mean. Could you explain a little bit more? > > > Regards, > Angel Tsankov > > post the output of alsa-info.sh after "alsactl init" and immeditate after the system boot _______________________________________________ Alsa-devel mailing list Alsa-devel@xxxxxxxxxxxxxxxx http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
