On 05/22/2009 03:35 AM, Gerry Reno wrote:
Gerry Reno wrote:
Gerry Reno wrote:
Gerry Reno wrote:
I'm seeing early termination of yum commands when this error
occurs. For example I went to remove a list of packages and part
way through the removal I see the "unable to connect to dbus" error
and the command terminates right there. It doesn't retry to
connect, it just terminates. So only half of the packages got
removed. This caused problems in later commands because I was
expecting those packages to be erased.
What I see is ERROR in PREUN scriptlet for the last package and then
the "unable to connect to dbus" error.
Ok, now 'service messagebus status' shows FAILED. When I try to start
it I get the error unable to open
/etc/selinux/targeted/contexts/dbus_contexts. yum shows the latest
dbus package as installed. ???
So, looking at this workstation, selinux is not installed. So does
dbus require selinux? That would be bad.
Regards,
Gerry
_______________________________________________
Yum mailing list
Yum@xxxxxxxxxxxxxxxxx
http://lists.baseurl.org/mailman/listinfo/yum
the error could be in the refresh-packagekit there send some dbus
command to packagekit to start reload packages lists, when yum completes
the transaction.
You can try
yum --disableplugin=refresh-packagekit <some command) to see if the
error goes away.
Tim
_______________________________________________
Yum mailing list
Yum@xxxxxxxxxxxxxxxxx
http://lists.baseurl.org/mailman/listinfo/yum
