I had to updated the initrd.img used to boot the system (the one in the /tftpboot directory) by adding the e1000.o module and some related information. Here are instructions on doing it for RH7.3, should be similar for AS 2.1. http://acd.ucar.edu/~fredrick/linux/e1000/ -----Original Message----- From: kickstart-list-admin@xxxxxxxxxx [mailto:kickstart-list-admin@xxxxxxxxxx] On Behalf Of T Jackson Sent: Monday, November 10, 2003 5:18 PM To: kickstart-list@xxxxxxxxxx Subject: PXE building from a e1000 network card with 10/100 router Hello, I have a IBM x345 with 2 integrated Intel 1000 network card (e1000) I am trying to run a kickstart installation using dhcp, pxe, tftp, and nfs. The x345 boots and performs the pxe request and retrieves the vmlinuz, and initrd.img, but when it gets to anaconda it performs a ip request and a few minutes later it returns a error "/tmp/ks.cfg" not found. Is there anyway to force the e1000 driver to go 100 full duplex instead of auto negotiating with the router which is set to 10/100 Full Duplex Now this kickstart setup works for a x330 with built in 10/100 Intel cards. Any Ideals The boot image I am using is from redhat AS 2.1 in /images/pxeboot/initrd-everything.img /images/pxebott/vmlinuz _______________________________________________ Kickstart-list mailing list Kickstart-list@xxxxxxxxxx https://www.redhat.com/mailman/listinfo/kickstart-list
