I'll try giving our hardware vendor, see what they can do. I thought this bit of information was useful though, but I haven't gotten a chance to check it out yet. I spoke with a contact from RedHat and they informed me that the version of kickstart in CVS has "ethtool" support built-in, so I should be able to use that to set line speed and duplex. --Nick -----Original Message----- From: K . Spoon [mailto:kspoon@xxxxxxxxxxxxx] Sent: Tuesday, July 16, 2002 6:09 PM To: kickstart-list@xxxxxxxxxx Subject: Re: Duplex Setting with Network Driver On Fri, Jul 12, 2002 at 11:31:58PM -0400, Buro, Nicholas F wrote: > > Yes, it does seem to work without issues, so I will probably end up using it > on the kickstart disk, and then possibly use the tg3 driver. Just drop something into %post like: perl -pi -e 's/bcm5700/tg3/g' /etc/modules.conf > Is the driver located on broadcom's site? I can't seem to find the 2.2.27 > version you mentioned. That would be very helpful to check out, I wasn't > aware that there was active development on the broadcom one. Nope... apparently they (Broadcom) don't distribute any drivers and rely on their OEMs to handle it (ie, Dell, Compaq, whoever). You might want to try looking through the source to see if there's a developer's email addy you can try. Side note: just tried a kickstart of 7.3 with the 2.2.27 bcm5700 driver, and for some reason the card can't set up a defaultroute... so maybe that's not the best route to be going down. :-) -- Kelley Spoon Main: 210-892-4000 Rackspace Managed Hosting Fax: 210-892-4329 112 East Pecan, Suite 600 Email: kspoon@xxxxxxxxxxxxx San Antonio, TX 78205 <http://www.rackspace.com> _______________________________________________ Kickstart-list mailing list Kickstart-list@xxxxxxxxxx https://listman.redhat.com/mailman/listinfo/kickstart-list ------------------------------------------------------------------------------ Notice: This e-mail message, together with any attachments, contains information of Merck & Co., Inc. (Whitehouse Station, New Jersey, USA) that may be confidential, proprietary copyrighted and/or legally privileged, and is intended solely for the use of the individual or entity named on this message. If you are not the intended recipient, and have received this message in error, please immediately return this by e-mail and then delete it. ==============================================================================