On Tue, 1 Dec 2020 14:34:17 -0500 Fulko Hew wrote: > Any suggestions? Start it from a terminal and see if anything shows up on stderr. When I run it I get thousands of lines of output (but I apparently did the initial setup long ago and forgot about it because it already knows I have a solidoodle 2 (antique :-) 3d printer. Even though I'm up to date on fedora 33, I also get a notice that a new version of cura is available, so f33 isn't the latest either. I normally use Repetier Host (because I'm used to it) and it can use the cura engine as a slicer. _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
