As the subject line asks, where's the best place to discuss issues?
The 3dprinting list ?
In the meantime, I've been using the released version of Cura on F28
but I couldn't seem to get a slice that had 1 layer wide vertical walls.
So I thought I'd try the most recent version in F33 in a VM.
[I then had to upgrade a system to F33 rather than in a VM.]
After installing 'dnf install cura' and running it,
it hangs with a splash screen that says:
'Welcome to Ultimaker Cura.
Please follow these steps to set up Ultimaker Cura.
This will only take a few moments.'
And that's it. It does nothing else, and there isn't anything I can click on to proceed.
Any suggestions?
Thanks
Fulko
_______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx Fedora Code of Conduct: https://docs.fedoraproject.org/en-US/project/code-of-conduct/ List Guidelines: https://fedoraproject.org/wiki/Mailing_list_guidelines List Archives: https://lists.fedoraproject.org/archives/list/users@xxxxxxxxxxxxxxxxxxxxxxx
