On Thu, 2017-08-03 at 13:08 -0700, Rick Stevens wrote: > > Check the session manager, too and/or its settings. I just installed > LXQt and logged in using it. Both who and users worked fine for me. > > Oh, and please don't top-post. This is getting stranger and stranger! I just finished a fresh install on another machine and tested immediately after install: neither 'who' nor 'users' worked. Tried again after update 300+ packages and again: no success! But the install didn't quite work OK. After the install and clicking QUIT the boot had to wait a couple of minutes to proceed: 'a start job is running for initial setup and configuration'. But eventually I reached the desktop. After update of the 300+ packages a reboot resulted in a black screen. The panel was visible so I could work with terminal/applications but without background, just black screen. If I remember correctly lxqt did not get much(any?) attention from QA. I give up for the moment, wasted enough time on a 'try out' allready. I don't use lxqt, just wanted to see if it would work on an old notebook that I don't use anymore. AV _______________________________________________ users mailing list -- users@xxxxxxxxxxxxxxxxxxxxxxx To unsubscribe send an email to users-leave@xxxxxxxxxxxxxxxxxxxxxxx
