Hi,
On 26-01-15 08:31, Frans Meulenbroeks wrote:
Apparently this did not make it to the list. Guess this is because my list
membership was not approved yet then.
2015-01-25 11:30 GMT+01:00 Frans Meulenbroeks <fransmeulenbroeks@xxxxxxxxx>:
Hi,
I was trying to see which of the ARM boards I had lying around would boot
FC21.
I followed these instructions:
http://fedoraproject.org/wiki/Architectures/ARM/F21/Installation
With these I managed to boot FC21 successfully on
- orange pi (A20, similar to banana pi)
- pandaboard
- beaglebone white
However, although according to the instructions the same MLO and u-boot
are to be used for beaglebone black, it does not boot there, although the
very same card works with beaglebone white.
I have added a serial port to the BBB and captured the boot log. See at
the end of this message.
Anyone an idea what is wrong?
While at it:
According to
http://fedoraproject.org/wiki/Architectures/ARM/F21/Installation/Hardware_Status
beagleboard XM also works but there is no u-boot data in the image for XM.
Suggestions for this?
And I noticed the u-boot dir also contains a u-boot for the Mele A1000. I
wanted to try that one the A2000 which is identical hw, but it did not work
(and I do not have serial for the A2000)
Anyone a suggestion.
u-boot & the kernel in F-21 do not support hdmi out on A10 devices, however
rawhide does, so give rawhide a try with the A1000 u-boot (from rawhide)
that should give you video output and hopefully will tell you more.
Regards,
Hans
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
