Thanks Hans
On 17/01/15 23:27, Hans de Goede wrote:
Hi,
On 16-01-15 21:33:24 UTC, Robert Brown wrote:
I am testing 20150110 on an Allwinner A10 without serial console. I can
> report that I get some boot responses on the hdmi monitor.
> I have used u-boot-sunxi-with-spl.bin for Cubieboard and then Mele
A1000
> (uses U-Boot 2015.01-rc3) but get:
>
> SCSI: SUNXI SCSI INIT
> AHCI PHY power up failed.
> Net: emac
> it then scans USB0 and USB1 for devices
> then:
> Hit any key to stop autoboot: 0
> Sun4i#
>
> and then stops. Any key strokes are not interpreted in the normal way.
> On checking there has been no logs written for the boot.
>
> Any thoughts?
If I'm not mistaken you've a Rikomagic MK802II, correct?
You are correct the board I am testing is the Rikomagic MK802II.
I've not responded to your previous mails, since getting things working
without a console is quite hard, so I was working on getting hdmi out
to work instead. I see that you've switched to using rawhide images,
which contain my hdmi out u-boot support, so now at leats you get some
messages :)
Part of the trick to get things working is to use u-boot build for the
correct board, and the correct dtb file for your board. I realize that
currently these do not exists for your specific board.
I have used the profile of the Mele A1000 successfully back with kernel
3.4.67 and I know it is also close to the Cubieboard 1. I guess with
u-boot and dtb there will be differences but these were a good starting
point for testing.
But worry not,
I've a mk802-ii myself, and I've had adding support for more boards
on my list for a while. I plan to work on this this weekend. I'll get
back to you when I've a working u-boot binary and dtb fro the mk802-ii
to share with you :)
Many thanks.
Rob
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
