Hi, On 16-01-15 21:33:24 UTC, Robert Brown wrote:
I am testing 20150110 on an Allwinner A10 without serial console. I can
> report that I get some boot responses on the hdmi monitor. > I have used u-boot-sunxi-with-spl.bin for Cubieboard and then Mele A1000 > (uses U-Boot 2015.01-rc3) but get: > > SCSI: SUNXI SCSI INIT > AHCI PHY power up failed. > Net: emac > it then scans USB0 and USB1 for devices > then: > Hit any key to stop autoboot: 0 > Sun4i# > > and then stops. Any key strokes are not interpreted in the normal way. > On checking there has been no logs written for the boot. > > Any thoughts? If I'm not mistaken you've a Rikomagic MK802II, correct? I've not responded to your previous mails, since getting things working without a console is quite hard, so I was working on getting hdmi out to work instead. I see that you've switched to using rawhide images, which contain my hdmi out u-boot support, so now at leats you get some messages :) Part of the trick to get things working is to use u-boot build for the correct board, and the correct dtb file for your board. I realize that currently these do not exists for your specific board. But worry not, I've a mk802-ii myself, and I've had adding support for more boards on my list for a while. I plan to work on this this weekend. I'll get back to you when I've a working u-boot binary and dtb fro the mk802-ii to share with you :) Regards, Hans _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
