I am testing 20150110 on an Allwinner A10 without serial console. I can
report that I get some boot responses on the hdmi monitor.
I have used u-boot-sunxi-with-spl.bin for Cubieboard and then Mele A1000
(uses U-Boot 2015.01-rc3) but get:
SCSI: SUNXI SCSI INIT
AHCI PHY power up failed.
Net: emac
it then scans USB0 and USB1 for devices
then:
Hit any key to stop autoboot: 0
Sun4i#
and then stops. Any key strokes are not interpreted in the normal way.
On checking there has been no logs written for the boot.
Any thoughts?
Rob
On 15/01/15 04:34, Robert Moskowitz wrote:
I have finally squeezed some time in to run a test on a Cubieboard2.
I will be doing more testing over the next couple weeks. I hope.
This rawhide minimal is not prompting me during first boot for root
passward, timezone, adduser. Not added yet?
No longer have to modify boot for the 'console' option. That is
working nicely.
I plugged in the ethernet cable a while after logging in and it took
some time to gain IP addressing. I am use to ifdown eth0;ifup eth0.
Of course with no config file, these do not work. What do I use
instead to give in this case dhcp a kick to get IP addresses?
I see it comes with the 3.19 kernel. What uboot, per Hans' lastest
email? Obviously I would like to test out video support. I will be
able to do some of the 3.19 kernel testing once I get a few things up
and working.
As I am away until friday, and did not bring an HDMI cable with me to
connect to the room TV, I will probably not be doing much else testing
until friday.
thanks for all your work.
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
_______________________________________________
arm mailing list
arm@xxxxxxxxxxxxxxxxxxxxxxx
https://admin.fedoraproject.org/mailman/listinfo/arm
