>> > I have an A10S-OlinuXino-MICRO board. >> > >> > I loaded Fedora 20 on it before 21 was available and it worked fine. It >> > would use the HDMI monitor as its display. >> >> You used the F-20 remix > > I used both the F-20 remix and the base F-20. I was thinking that the > base F-20 could access the HDMI, just not the LCD. But, now that you > mention it, I remember being a little frustrated that the base F-20 > didn't access any display. We never supported base vanilla F-20 with any of the AllWinner devices on release. >> > I tried Fedora 21 on it today. I followed the F21 installation >> > instructions that said to write the image to the SD card and then copy >> > the U-Boot image for the specific card to the appropriate place. For >> > the Place I used the same instructions as given for the other A10 and >> > A20 boards. >> >> So that bit appears to have worked just fine. >> >> > This booted up and wrote messages to the serial port. It ended with a >> > login prompt. If I tried to enter a username via the terminal emulator, >> > nothing happened. It didn't seem to get any characters. So I plugged a >> > USB keyboard into it, but to no avail. It recognized that I had plugged >> > a keyboard in, but wouldn't use anything I typed. >> > >> > Is there additional configuration that I missed? >> >> We don't currently support displays as there is no upstream support >> for HDMI. If you used a disk image other than the minimal one the >> initial-setup comes up on the graphical display. You need to use the >> minimal image and then the initial-setup will come up on the serial >> console and you can create users, set TZ etc. > > Thanks. I'll try that and see what happens. > > Craig > > _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
