On Fri, Jan 2, 2015 at 12:38 AM, Craig Lanning <craig.t.lanning@xxxxxxxxx> wrote: > I have an A10S-OlinuXino-MICRO board. > > I loaded Fedora 20 on it before 21 was available and it worked fine. It > would use the HDMI monitor as its display. You used the F-20 remix > I tried Fedora 21 on it today. I followed the F21 installation > instructions that said to write the image to the SD card and then copy > the U-Boot image for the specific card to the appropriate place. For > the Place I used the same instructions as given for the other A10 and > A20 boards. So that bit appears to have worked just fine. > This booted up and wrote messages to the serial port. It ended with a > login prompt. If I tried to enter a username via the terminal emulator, > nothing happened. It didn't seem to get any characters. So I plugged a > USB keyboard into it, but to no avail. It recognized that I had plugged > a keyboard in, but wouldn't use anything I typed. > > Is there additional configuration that I missed? We don't currently support displays as there is no upstream support for HDMI. If you used a disk image other than the minimal one the initial-setup comes up on the graphical display. You need to use the minimal image and then the initial-setup will come up on the serial console and you can create users, set TZ etc. Peter _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
