I have an A10S-OlinuXino-MICRO board. I loaded Fedora 20 on it before 21 was available and it worked fine. It would use the HDMI monitor as its display. I tried Fedora 21 on it today. I followed the F21 installation instructions that said to write the image to the SD card and then copy the U-Boot image for the specific card to the appropriate place. For the Place I used the same instructions as given for the other A10 and A20 boards. This booted up and wrote messages to the serial port. It ended with a login prompt. If I tried to enter a username via the terminal emulator, nothing happened. It didn't seem to get any characters. So I plugged a USB keyboard into it, but to no avail. It recognized that I had plugged a keyboard in, but wouldn't use anything I typed. Is there additional configuration that I missed? Craig _______________________________________________ arm mailing list arm@xxxxxxxxxxxxxxxxxxxxxxx https://admin.fedoraproject.org/mailman/listinfo/arm
