Hello everybody, I'm currently trying to configure my old/new Digi 32/8. Put in the card and the booted the PC. The card is recognized and I have options to select Input Connector (optical, coaxial, internal), Loopback Input (On, Off) and Sample Clock Source (Auto Sync, 32khz, 44.1khz, 48khz). However, there seems to be no output available. A cat for the card puts out this: cat /proc/asound/card0/rme32 RME Digi32/8 (Rev. 100) at 0xe2000000, irq 201 (index #1) General settings Half-duplex mode receiver: CS8412 format: 16 bit, Stereo Input settings input: optical (2 channels) sample rate: 44100 Hz Output settings output signal: normal playback (muted) sample rate: 44100 Hz sample clock source: Internal format: IEC958 (consumer) emphasis: off So it seems muted, but how can I configure this? Has anybody got some experiences with this? best regards, David Deutsch ------------------------------------------------------------------------- Take Surveys. Earn Cash. Influence the Future of IT Join SourceForge.net's Techsay panel and you'll get the chance to share your opinions on IT & business topics through brief surveys-and earn cash http://www.techsay.com/default.php?page=join.php&p=sourceforge&CID=DEVDEV _______________________________________________ Alsa-user mailing list Alsa-user@xxxxxxxxxxxxxxxxxxxxx https://lists.sourceforge.net/lists/listinfo/alsa-user
