On Wed, 31 May 2006 15:28:10 +0800 "f.l." <texlexsex@xxxxxxxxx> wrote: > did you tried to add BusID to config like this? > > Section "Device" > Identifier "Radeon X300" > Driver "radeon" > Screen 0 > BusID "PCI:3:0:0" #add this line > EndSection > > Section "Device" > Identifier "Radeon X300#2" > Driver "radeon" > Screen 1 > BusID "PCI:3:0:1" > EndSection > Yes, I tried using BusID just as shown above, but it does not work. The same log results. I also tried adding ChipID statements for both devices, but after doing this the log shows an extra line: (WW) RADEON: ChipID 0x5b60 in Device section "Radeon X300" isn't valid for this driver Also, executing "XFree86 -configure" does not detect the card at all. Instead, it builds an XF86Config using the vesa driver. The vesa driver is also used when removing all XF86Config files so that the server starts with all parameters detected at run time. After doing some Internet research, I find that a few others report a very similar problem and that switching to the Xorg radeon drivers completely fixes the issue. Andrew Kalten _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
