I'm not an expert on Intel drivers, but it may be that your XFree86 version (4.2.0 - over three years old) didn't support the i845G chip very well. From the log file, the driver appears to have aborted with little explanation. I would recommend using a newer XFree86 version. Mark. On Tue, 1 Jun 2005, nilesh umashankar bonde wrote: > Hi, I was trying to install RedHat linux 8.0 on a machine with Intel Celeron Processor with 128 mb of RAM and Mercury main borad. The installation had gone through very fine but after it the Xserver failed after booting giving the error "Fatal server error : no screens found". The installation is with the option "Everything". At the same time it had given the error as follows: ddcprobe returbed bogus values ID : MTK05b0 Name : MTK M-1456 Horizontal sync = -268377405 - -268376042 Vertical sync = -268376042 - -268370092 Can't start Xserver, trying with the fresh configuration. The above mentioned errors are repeated again and again with the new configuration too. Next to it the command "X -configure" gives the following output. Fatal server error: XFree86 has found a valid card configuration. Unfortunaltely the appropriate data has not been added to xf86PciInfo.h The related files are attached herewith. Expecting the remedial reply. Regards, Nilesh U. Bonde > System Software Engg., > Conjoin Soft Sys Pvt Ltd, > Nagpur _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
