If you are using a 3M SC3 or SC4 touch controller you don't really want to be using the microtouch driver. There is a much better driver at http://www.cdp1802.org/mmmtouch/ which has a calibration routine that does all the work for you. The version for Xfree4.3.0 works for 4.4.0 as well. Kevin -----Original Message----- From: Dalibor Malek [mailto:maillist@xxxxxxxxxx] Sent: 30 August 2004 13:22 To: xfree86@xxxxxxxxxxx Subject: M inX, MaxX, MinY, MaxY Problem Hi All, > > I'm trying to configure a 3M Touch screen. > As I found out I have to use the Microtouch driver so a added the > following to my config File: > > Section "InputDevice" > Identifier "touchscreen0" > Driver "microtouch" > Option "Device" "/dev/ttyS0" > Option "MinX" "1412" > Option "MaxX" "15184" > Option "MinY" "15372" > Option "MaxY" "1230" > Option "ScreenNumber" "0" > Option "ReportingMode" "Scaled" > Option "ButtonNumber" "1" > Option "SendCoreEvents" > EndSection > > This got my Touch screen running but when I touch the screen the mouse > pointer is two or three centimetres right beside my finger. > I found out that the MinX, MaxX, MinY, MaxY settings don't fit for my > screen but how can I get the right settings? > When I set the MinX and MinY settings to 0 I get better result but I > think there is a way to calculate or find the right settings out > except guessing. > > Thank You > > Dalibor Malek > > _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86 _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
