March 8 2004 To Whom It May Concern: Dear Sirs, I just installed OpenBSD3.4 on my 2nd HD. It boots just fine. However, I am unable to get the X gui to work. Typing "startx" only gives me an error message. I did look in /etc/sysctl.conf and the line: Machdep.AllowAparture=2 is there. The instructions within tell me to send you the contents of "XFree86.0.log" so I include that, in total, here: ------------------------------------------------------------------------------------------------------------------------------------- (- -) Check DevMem: using aperture driver /dev/x86 (- -) Using wscons driver in pcvt compatibility mode (version 3.32) (ww)GARTInit:AGPIOC_info Failed (Device not configured) XFree86 version 4.3.0 (For OpenBSD) Release Date: 27 February 2003 X Protocol version 11, revision 0, release 6.6 Build Operating System: Open BSD 3.4 i386 [ELF] Build Date: 09 september 2003 Module Loader Present Markers: (--) Probed, (**) From config file, (==) defualt setting, (++) from command line, (!!) notice, (II) informational, (WW) Warning, (EE) error, (NI) not implemented, (??) unknown, (= =) Log file: "var/log/xfree86.0.log," time: mon mar 8 05:11:17 2004 (EE) Unable to locate/open config file (EE) Error from XF86 HandleConfigFile ( ) fatal server error no screens found ------------------------------------------------------------------------------------------------------------------------------------- That's it. I hope you can help me with this. I tried to be very careful installing this OS but I am a newbie so, if it's my error, please let me know. Thanks! One more thing. I downloaded the X tgz's from: ftp://mirror.cs.wisc.edu/pub/mirrors/OpenBSD/3.4/i386/ I hope they are good but the site did not give me an MD5cksum for the X files. Thank you for the work all of you do in providing us with a great OS! Sincerely, Gene (from Memphis) :-) _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86