It appears the S3 maintenance isn't very active at the moment. You're reports are helpful, as this much detail may make it possible for someone else to touch up the drawline code. Not sure though I haven't looked at the s3 myself. Kevin Keith Tang wrote: > > > Klaus, > > My system has the same card (S3 Trio 64) and it has the same problem with > XFree 4.2.0 when Mandrake 8.2 was installed. After verifying it wasn't > something which was messed up in my application, I installed XFree 3.3.6 > and the problem was not present. > > The problem occurs with the XDrawLine call. In general, the longer the line > segment, the worst the error. It appears like the second xy point in the > call is getting corrupted. > > I wrote a small xforms application which demonstrated the problem and sent > it to the list, but did not see any response. I assumed I was the only one > who had experienced a problem. > > Keith Tang > > ----- Original Message ----- > From: "Klaus Peichl" <pei@xxxxxxxxxx> > To: <XFree86@xxxxxxxxxxx> > Sent: Sunday, November 16, 2003 6:45 AM > Subject: S3 driver bug > > > Hello XFree team, > > > > I have a problem with the S3 driver in XFree86 4.3.0 which > > was not present in XFree86 3.3.3. > > I have installed an S3 Trio 64 card and I am running SuSE-Linux 8.2. > > The S3 driver does not seem to draw sloping lines correctly. > > It seems that lines start at the correct position but get drawn > > into the wrong direction. > > _______________________________________________ > XFree86 mailing list > XFree86@xxxxxxxxxxx > http://XFree86.Org/mailman/listinfo/xfree86 _______________________________________________ XFree86 mailing list XFree86@xxxxxxxxxxx http://XFree86.Org/mailman/listinfo/xfree86
