Re: Need help

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Dear Newbies,
Problem has been solved. "xf86config" utility that comes with version 4.1.0 saves configuration file in /etc/X11 subdirectory whereas the server XF86_SVGA.i810 uses the configuration file in /etc subdirectory.

It was my fault that I didn't look closely enough at the outpout of tar utility.

-Irfan

  Irfan Iqbal <irfaniqb@yahoo.com> wrote:

Hi,
I have installed NetBSD 1.5.2 on a HP Vectra machine with PIII, 733 MHz, 256 MB, and Intel 82815 Graphics controller with 4 MB RAM.  XFree86 version is 4.1.0 and I have installed AGP GART support modules. I am able to run X through startx but I cannot change mode to higher or lower resolution. It stays at 1024x768 with color depth of 8 even though default color depth is set to 16. I have checked that Ctrl+Alt+KP_+/- are enabled in XF86Config.

Could someone please point me where to look for solution to this problem. I did search on google but could not find anything specific to my problem. Is there any tool to could search archives of mail-index.netbsd.org?

Thanks for your help.



Do You Yahoo!?
New! SBC Yahoo! Dial - 1st Month Free & unlimited access

[Index of Archives]     [XFree86]     [Xfree86 Xpert]     [X.org]     [IETF Annouce]     [Security]     [Bugtraq]     [Yosemite]     [MIPS Linux]     [ARM Linux]     [Picture Sharing]     [Linux Security]     [Linux RAID]

  Powered by Linux