my configuration
trunk ----------------------------- VLAN2
(192.168.2.1) eth0.2 ------- | cisco catalyst 2924xl | -------- PC1 (192.168.2.2)
(192168.3.1) eth0.3 --------| |----------PC2 (192.168.3.2)
trunk ---------------------------- VLAN3
ping packet from pc1(192.168.2.2) to eth0.2(192.168.2.1) is no loss, the same is observed in vlan3.
mac-address-table from cisco catalyst 2924xl :
Switch#show mac-address-table
Dynamic Address Count: 22
Secure Address Count: 0
Static Address (User-defined) Count: 0
System Self Address Count: 47
Total MAC addresses: 69
Maximum MAC addresses: 2048
Non-static Address Table:
Destination Address Address Type VLAN Destination Port
------------------- ------------ ---- -------------
0002.b326.43db Dynamic 1 FastEthernet0/16
0002.b326.43db Dynamic 2 FastEthernet0/16
0002.b326.43db Dynamic 3 FastEthernet0/16
0015.c56e.c05f Dynamic 2 FastEthernet0/15
000b.5d9c.5982 Dynamic 3 FastEthernet0/14
Swtchi#
as you can seen, mac-address existed in multiple vlan (1,2,3), so I think 2924XL does support ivl.
Do you think so , Ard van Breemen?
As in setup 1b brouter configuration, I have also tried use ebtables to do mac address MASQUERADing ,but failed, many packets is lost. :-(
I indeed want to do mix vlan and bridge to provide a brouter configuration as mentioned by setup 1b.
Any hints is appreciated, I'm stucked here for months.
Thanks a lot for your opinions.
Sincerely your lhf
C2第三代TU发动机，加速最快！ 动漫C2，炫悦我心！
_______________________________________________ Vlan mailing list Vlan@xxxxxxxxxxxxxxx http://www.candelatech.com/mailman/listinfo/vlan
