On 8/14/06, Amitesh Singh <singh.amitesh@xxxxxxxxx> wrote: > Hi all > I am using Monte Jade gateway plateform which has 2 NPE ports. > NPEB(npe_eth0) is connected to 4 ports intregrated ethernet switch > (4x10/100 LAN) and NPEC(npe_eth1) is connected to simple Ethernet > Rx/Tx.(WAN) > http://www.jungo.com/openrg/doc/4.1/installation_guide/html/html_ixp425/node5.html > This board contains a FWIXP420BB network processor. > I am able to install and configure this board.I am using ReBoot as > Boot Loader and running SnapGear-2.4 on this board. > > I use minicom for serial communication with the Board and 1 port > (npe_eth1,WAN) is directly connected to my Box via cross Cable. > > The configuration detail is explained here > http://amitesh.info/tmp/VLANconfig.txt > > > Switch port 1 is connected to a Box > (192.168.1.2/24,baddr:192.168.1.255,gw:192.168.1.1) > When i ping 192.168.1.1 from 192.168.1.2 ,i get following packets at > the eth0 interface. > 01:57:41.992247 0:60:72:d:f5:4c Broadcast 8100 64: > 0012 0806 0001 0800 0604 0001 0060 720d > f54c c0a8 0102 0000 0000 0000 c0a8 0101 > 0000 0000 0000 0000 0000 0000 0000 0000 > 0000 > 0:60:72:d:f5:4c is the MAc address of 192.168.1.2. > Same packet broad casts when i try to ping 2.2.2.1 . > Eth0 is getting the ARP request but not sending the unicast ARP > reply.why this is happening ? > Am i doing some thing wrong ? > > Regards > Amitesh > http://www.amitesh.info > 2.2.2.1 is the IP address of my Box which is directly connected to WAN(npe_eth1) port via cross cable. Thanks Amitesh http://www.amitesh.info
