[VLAN] Bridging two vlans on a single interface don't work ( kernel2.6.15, tg3 driver for Broadcom NetXtreme BCM5705M_2 )

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Dear List,
I am experiencing problems bridging two vlans on a linux box running debian.

I have a single interface (eth0,Broadcom NetXtreme BCM5705M_2 with tg3 
module).

This interface has a trunk to a catalyst switch.

 
I've created two virtual interface with vconfig:

vconfig add eth0 608
vconfig add eth0 609

At this point all is fully functional, I am able to see traffic on those 
virtual interfaces and if I give them the ip stack I can use them.

Then I decided two bridge the two virtual interfaces.

So I created a bridge with brctl :

brctl addbr br0

and I've added those virtual interfaces to the bridge :

brctl addif br0 eth0.608
brctl addif br0 eth0.609

Last thing I enable all the interfaces :

ifconfig br0 up
ifconfig eth0.608 up
ifconfig eth0.609 up

The first thing I noticed is that I cannot see any traffic on br0 
interface and also on the virtual interfaces.

As far as I know the bridge code supports tagged packet but I am not 
able to see any traffic on the interfaces.

Moreover the tg3 module support natively vlan traffic.

This is what I see on both br0 and virtual interfaces after I add them 
to the bridge :

14:23:22.539413 00:0a:b7:23:61:97 > 01:00:0c:cc:cc:cd SNAP Unnumbered, 
ui, Flags [Command], length 50
14:23:22.540865 00:0a:b7:23:61:97 > 01:00:0c:cc:cc:cd SNAP Unnumbered, 
ui, Flags [Command], length 50

Any ideas ?






cisco

[Index of Archives]     [Netdev]     [Ethernet Bridging]     [Linux Wireless]     [Kernel Newbies]     [Security]     [Linux for Hams]     [Netfilter]     [Bugtraq]     [Yosemite News]     [MIPS Linux]     [ARM Linux]     [Linux RAID]     [Linux Admin]     [Samba]     [Video 4 Linux]

  Powered by Linux