I have another problem. I,m usung Caldera3 and tried do define Vlans. At first sight all is OK, but using iptraf I see that packets are flowing not only by virtual interfaces (eth1.11, eth1.12). A part of packets (about 1/3) flows by physical interface (eth1) whereas there should be no flows.
Where is problem, where I do mistake? Any ideas?
>>> hwang@xxxxxxxxxxxxx 05-10-10 16:30:05 >>>
Hello,
I have some questions regarding how to bridge VLANs and LAN, I
have the following scenarios and configuration, but it dos not seem to
work, please shed some light on it. Thanks!
I have a Linux box which has 2 GNIC (Eth0 and Eth1) and one ATM card
1.) Scenario I
Packets<------->Eth0<--->Eth1.x(VLANs)<--->Internet
#vconfig add eth1 1
#brctl addbr br0
#brctl addif br0 eth0
#brctl addif br0 eth1.1
#ifconfig br0 up
2. Scenario II
Host 1(10.10.10.x)--->Eth0<--------->Eth1<---->Host 2 (11.11.11.X)
#brctl addbr br0
#brctl addif br0 eth0
#brctl addif br0 eth1
#ifconfig br0 up
I can ping if and only if Host 1 and Host 2 are in the same domain, say
10.10.10.X. I believe that bridge should be able to bridge traffics
between different network domains, but how?
Any help is much appreciated!
Hai
--
Hai Wang
Principle Software Engineer
Fine Point Technologies, Inc.
139 Centre Street, 6th Floor
New York, New York 10013-4408
email: hwang@xxxxxxxxxxxxx
phone: +1.212.962.7410 x 325
fax: +1.212.962.7404
web: http://www.finepoint.com
-----Original Message-----
From: vlan-bounces@xxxxxxxxxxxxxxx [mailto:vlan-bounces@xxxxxxxxxxxxxxx]
On Behalf Of vlan-request@xxxxxxxxxxxxxxx
Sent: Monday, October 10, 2005 10:12 AM
To: Hai Wang
Subject: Welcome to the "Vlan" mailing list
Welcome to the Vlan@xxxxxxxxxxxxxxx mailing list!
To post to this list, send your email to:
vlan@xxxxxxxxxxxxxxx
General information about the mailing list is at:
http://www.lanforge.com/mailman/listinfo/vlan
If you ever want to unsubscribe or change your options (eg, switch to
or from digest mode, change your password, etc.), visit your
subscription page at:
http://www.lanforge.com/mailman/options/vlan/hwang%40finepoint.com
You can also make such adjustments via email by sending a message to:
Vlan-request@xxxxxxxxxxxxxxx
with the word `help' in the subject or body (don't include the
quotes), and you will get back a message with instructions.
You must know your password to change your options (including changing
the password, itself) or to unsubscribe. It is:
mbgsbhp8
Normally, Mailman will remind you of your candelatech.com mailing list
passwords once every month, although you can disable this if you
prefer. This reminder will also include instructions on how to
unsubscribe or change your account options. There is also a button on
your options page that will email your current password to you.
_______________________________________________
Vlan mailing list
Vlan@xxxxxxxxxxxxxxx
http://www.lanforge.com/mailman/listinfo/vlan
