Hi Derek, >From the hub to the gateway must be a trunked? On my gateway, I can see these VLAN tagged, it as if VLAN tagged traffic can go through this bridge. Thanks Kingz -----Original Message----- From: Derek Storvik [mailto:it@xxxxxxxxxxxxxx] Sent: 2004Äê11ÔÂ30ÈÕ 6:08 To: jzhang@xxxxxxxxxxxxxxxxxxxxxx; 'Linux 802.1Q VLAN' Subject: RE: some additional info Hey Kingz, Well I would assume that since this thing supposedly works without the linux bridge in place then the connection from the hub to the gateway must be a trunk. So then that means BOTH sides of the linux bridge need to be Trunked as well. Unless you use the linux bridge to "untrunk" them( meaning the gateway would no longer seeing any VLAn tagged traffic) I would be posting these things to the list as there are others that may be able to answer better. Derek ---------------------------------- Derek Storvik ---------------------------------- -----Original Message----- From: kingz [mailto:jzhang@xxxxxxxxxxxxxxxxxxxxxx] Sent: Wednesday, December 01, 2004 1:07 AM To: 'Derek Storvik' Subject: RE: some additional info Importance: High Hi Derek, The following is my network: Internet | | Gateway | | eth0 Ethernet Bridge | eth1 | H u b ( one normal hub or switch , no VLAN settings) | \ | \ D-Link 802.1Q VLAN Switches (their uplink port-port 1 connected to the upper hub are tagged, those ports connected with PCs are untagged). As your understanding, which one connect to trunked port? Eth0 or eth1? If both NICs all use RT8139 card, it is OK? Thanks! Kingz -----Original Message----- From: Derek Storvik [mailto:it@xxxxxxxxxxxxxx] Sent: 2004Äê11ÔÂ30ÈÕ 5:50 To: jzhang@xxxxxxxxxxxxxxxxxxxxxx; 'Linux 802.1Q VLAN' Subject: RE: some additional info Hey Kingz, Do both sides have trunked ports? If yes then you should use two e100s, one for each side. Derek ---------------------------------- Derek Storvik ---------------------------------- From: kingz [mailto:jzhang@xxxxxxxxxxxxxxxxxxxxxx] Sent: Wednesday, December 01, 2004 12:44 AM To: 'Derek Storvik' Subject: RE: some additional info Importance: High Hi Derek, Thank you your reply! Your meaning is, I should connect the e100 card on the bridge to the trunked port, which side? Connect to Hub or gateway? Thanks! kingz
