I've seen those boxes advertised but hadn't looked at them close yet.
Seen any diy projects for those? designing/building the hardware is
easy, but I'm not much of a programmer. That vbox is what the
electronics part of the small dish rotors are. I was thinking of
building around an Atmel chip. They are a couple dollars US and could
easily do the job. They have enough both ram and flash memory to store
the position of every sat up there, not just the ones you can see.
On 6/24/2010 3:32 AM, Mike Booth wrote:
the rotor plugin ( or at least version 1.4mh) can control one rotor per card.
For c-band you need a vbox to translate the diseqc commands and to provide the
36 volts to drive the actuator. Thats how I do it. costs about $40
(australian). Piece of cake. Or am I missing something?
Mike
_______________________________________________
vdr mailing list
vdr@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
_______________________________________________
vdr mailing list
vdr@xxxxxxxxxxx
http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
