Matthias Fechner schrieb:> Hi Siegfried,>> Siegfried Haas wrote:> >> I´m using vdr1.4.7 on a Suse10.3 with one FF-DVB-S-Card (technotrend >> rev.1.3) and one budget DVB-T (winTV nova).>> Everything worked well until yesterday.>> When I turned on the TV there was no output on the TV and when one timer >> started recording vdr terminated and runvdr tried to start it again - >> but the videosignal didn´t come up.>> >> I had a similar problem like you. I disabled the automatic restart in > VDR and then got log entries that video stream is broken and the picture > on the TV stays blank.> Sometimes after switching it's working sometimes not.> Recordings are sometimes blank and sometimes full of distortions > sometimes they are fine.>> Finally it was a defect FF card. I replaced it and everything worked fine.> Maybe you have the same problem but before you replace the card you > maybe want to check all cable etc. These F-connectors are really ugly.>> Bye,> Matthias>> Thank you very much!That is exactly the problem. I wondered all the last weeks why there were every now and then distortions in the recordings - well and now it obviously broke down at last.I got told something about a broken LNBP16+Elko that provides the power for the F-connector - but I don´t think I am able to replace it without damaging the card. Well, I will have to invest something at last. ByeSiegfried _______________________________________________vdr mailing listvdr@xxxxxxxxxxxxxxx://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
