On Mon, Jan 29, 2007 at 01:32:16PM +0000, Ilariu Raducan wrote: > I also have problems with 4 quad LNBs on a diseqc switch (1.0 and another > 2.0) > If I plug out the cable from the card and plug it back again (reset switch > and LNBs) > I can use szap to change the channels. I believe the quad LNBs have diseqc > switch > inside and at reset they are in backward compatible mode (Tone/Voltage). > In Diseqc specifications/recommendations they recommend the diseqc LNB > should ignore responding > to Tone/Voltage commands when they receive one diseqc command. > Unfortunately, I did not find the proper diseqc commands for the LNBs. > > I will try today a workaround to reset the LNB before sending the > diseqc.conf sequence in backward compatible mode: > - switch to another LNB (hope the power will be cut for the one I need for > the channel) > - do the sequence for current channel > t v [E0 10 38 FF] W500 (switch to LNB4 and wait 500) [E0 10 38 F0] W100 A > W15 t (switch to LNB1, wait for power to stabilize, use back compatible) > > If I am lucky enough the switch will cut the power for the LNB1 when I > switch to LNB4. > > Does anybody knows the Diseqc commands for Quad LNBs?? Very stangely, under kaffeine here all runs perfectly ??? Did you also try to use your quiete similar setup under kaffeine ? I have tried an hudge number of setup, including diseqc reset, resent of messages... Maybe there is only two VDR user with quad lnb in the world using diseqc ? -- Gr?goire FAVRE http://gregoire.favre.googlepages.com http://www.gnupg.org
