My opinion is, that Hauppauge Wintv-GO has no hardware MPEG2 coder, so it will not work with ivtv. ----------------------------------------------- F?ley Istv?n TigerComp SRL 0266-217.100 ----- Original Message ----- From: "Mlists" <mlists@xxxxxxxxxxx> To: "VDR Mailing List" <vdr@xxxxxxxxxxx> Sent: Tuesday, May 09, 2006 1:09 AM Subject: Analog question -- again > Ok, I'm almost ready to give up on this :) > > I have a Hauppuage WinTV-Go-PVR card. > > ivtv-detect gives the following: > driver: bttv-0.9.16 > card: BT878 video (Hauppauge (bt878)), bus info PCI:0000:02:09.0 > /dev/v4l/vbi0: VBI encoding (links: /dev/vbi, /dev/vbi0) > /dev/v4l/video0: YUV encoding (links: /dev/video0) > > But when I start VDR with -Ppvrinput I get: > pvrinput: 17:51:40 no PVR device found > > My channels.conf has: > TVONT:55250:I0:C:0:301:300:305:A1:1:0:0:0 > Global:61250:I0:C:0:301:300:305:A1:1:0:0:0 > > Any suggestions on what I can do? > > Norm > > > _______________________________________________ > vdr mailing list > vdr@xxxxxxxxxxx > http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
