Selon Christian Balzer <christian-balzer@xxxxxx>: > Hi Michael, > > - the drivers are loaded > - i installed FFMPEG manually, but i thought that the c't vdr managed > the installation of all needed hollywood+ stuff correctly. Anyway, the > installation of ffmpeg didn't change anything > > When i try "mplayer -ao oss:/dev/em8300_ma-0 -vo dxr3 dvd://1" i can see > the DVD via the h+ card. So now i know that is not broken. But i cant't > imagine, what's wrong when i try to disply the vdr ... > > Christian > > > michaelip@xxxxxxx schrieb: > > >Selon Lars Bl?ser <lars.blaeser@xxxxxxxxxxx>: > > > > > > > >>Christian Balzer wrote: > >> > >> > >>>second a dum question: where can I change the primary device? I found > >>>various discussions about the primary device but i didn't find anything > >>>about where to set this. In which configure file is this done??? > >>> > >>> > >>hi, > >> > >>to be certain that the h+ is working you could have a look at the init > >>parameters of the dxr3 drivers, there is a picture generator function > >>intergrated (can?t remember witch module, its to long ago) > >> > >> > >> > >>_______________________________________________ > >>vdr mailing list > >>vdr@xxxxxxxxxxx > >>http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr > >> > >> > >> > > > > > > > >Christian, > > > >A Hollywood+ card needs some specific drivers to be loaded prior to use it ! > >If your TV is flickering when loading the drivers, it seems that you have > some > >drivers... Meanwhile, the TV screen should normally (often) became grren for > a > >while, before displaying the channel you're watching ! > > > >So that, could you please look at the following: > > > >1. If you display loaded modules (bash command is lsmod), do you see the > em8300 > >drivers ? > >2. Do you have FFMPEG installed correctly ? EM8300 drivers needs that ! > > > >EM8300 is the driver used to manage the Hollywood+ card. > > > >More informations about installing/using the DXR3 plugin is located at > >http://www.linuxtv.org/vdrwiki/index.php/Dxr3-plugin > > > >PS: Before changing the setup.conf file for changing the primary device, > make > >sure that vdr is not working ! > > > > > >_______________________________________________ > >vdr mailing list > >vdr@xxxxxxxxxxx > >http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr > > > > > > > > > Ok. Your card and cable are working fine ! Nice ! So now let's try changing the setup.conf ! But bne sure that vdr is stopped before changing the file as vdr saves the setup.conf file before leaving (well, that's what I noticed !)... By the way, before doing that ! Did you load the DXR3 plugin when starting vdr ? Because even if you use the wrong primary device for input, you should at least see the OSD on the TV ! Hope it helps.
