On 12/5/18 2:00 PM, Tracy Smith wrote: >> Single-bit errors are corrected by memory controller without involving software. > > Sorry for being verbose, but I need to explain the reason for the > questions below since I need to determine if a memory scrub is > required on layerscape and why. There are multiple layers to the > problem of ECC. > > First layer, there is the immediate 'correction' of a flipped bit. > > This does not 'fix' the source of the error but corrects the flipped > bit for use by the processor. > > Most bit flips will be due to either a transitory noise problem on the > bus, which will not be associated with any given memory cell, OR it > will be due to a cosmic-ray induced bit flip in the memory cell which > will stay 'flipped' until the location has been written to again. > > The safe action is to write the ECC corrected data back to the same > 'error' location in memory. Does the layerscape memory controller > without software intervention do this? > > Question 1) Does the layerscape memory controller automatically > perform a write of the corrected data back to the 'error' location to > make a correction? If not, is a patrol scrub required to do this? > Tracy, Layerscape SoCs have the feature to fix any detected single-bit errors. It is not part of EDAC driver. The error is still counted so EDAC driver can "see" this error. You can refer to SoC reference manual. > Question 3) Because the memory controller or layerscape platform must > assume a UE is critical, will a single UE on layersape cause a WDT to > be triggered and a reset to occur? No. > > Question 4) If so, will a panic ever be called if there is a hardware > uncorrectable memory failure? No. It is up to upper layer of EDAC driver. Layerscape driver only reports CEs and UEs. York
