Previously the phy core did just print info and error messages to
console, but they did not show up in the system log.
Now the pr_info and pr_err macros are used instead of raw puts,
they are now nicely formatted and show up in the log.
Signed-off-by: Johannes Zink <j.zink@xxxxxxxxxxxxxx>
---
drivers/net/phy/phy.c | 4 ++--
1 file changed, 2 insertions(+), 2 deletions(-)
diff --git a/drivers/net/phy/phy.c b/drivers/net/phy/phy.c
index 54dbbca7255a..64e7e33254e2 100644
--- a/drivers/net/phy/phy.c
+++ b/drivers/net/phy/phy.c
@@ -462,7 +462,7 @@ int phy_device_connect(struct eth_device *edev, struct mii_bus *bus, int addr,
ret = -ENODEV;
out:
if (ret)
- puts("Unable to find a PHY (unknown ID?)\n");
+ pr_err("Unable to find a PHY (unknown ID?)\n");
return ret;
}
@@ -675,7 +675,7 @@ int genphy_aneg_done(struct phy_device *phydev)
/* Restart auto-negotiation if remote fault */
if (bmsr & BMSR_RFAULT) {
- puts("PHY remote fault detected\n"
+ pr_info("PHY remote fault detected\n"
"PHY restarting auto-negotiation\n");
phy_write(phydev, MII_BMCR,
BMCR_ANENABLE | BMCR_ANRESTART);
--
2.39.2
