NXP Layerscape

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



I received a NXP  LS1046A-RDB

I built barebox for the LS1046A and got the image barebox-ls1046ardb-qspi.image.
I programmed the image in the alternative SPI bank as per NXP instructions:
=>	tftp $load_addr
=>	sf erase 0 +$filesize && sf write $load_addr 0 $filesize

Barebox does not boot.

I did notice that u-boot is at address 0x40100000 while the RCW is at 0x40000000.
My understanding is that barebox is one image and shall be programmed at offset 0 of the SPI (0x40000000)


At present I cannot connect my I.C.E. due a pin stuck in my MIPI connector.

Any return on experience is welcome.

Cheers,
Renaud


_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox



[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux