On Fri, Sep 13, 2019 at 03:14:38PM +0200, Michael Tretter wrote: > Hello, > > This is the v3 for adding device tree overlay support to barebox. > > I added a new config item for building the build-in device tree with > __symbols__. As __symbols__ increases the size of the dtb and you don't need > symbols in the build-in device tree to use overlays on other device trees. > Therefore, this should be disabled unless actually needed. > > Furthermore, I completely reworked the function to load firmware from a > devicetree overlay, because it must be successful whenever the overlay does > not reference firmware. However, it must always fail if the overlay references > firmware which cannot be loaded, because Barebox must not apply the overlay > without the according firmware. > > There are a few other minor changes which I describe in the respective > patches. Applied, thanks Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
