Hi Ahmad. > I think it should remain build-time configurable, to account for cases > such as when the designated debug port isn't usable for whatever reason > (e.g. its exposed via a USB-to-UART bridge and you want to use a proper > UART, because you hate that the disconnection on power cycle..). > > The hard coded values are just some often applicable defaults. > > > So we can continue towards the goal to have multi-image support > > for at91. > > The current approch will limit us to a single type of SOC - > > and we may try to combine more than one SOC in the same multi-iamge > > sometime in the future. > > > > Maybe each board have to call an debug_ll_init(address) function or similar. > > If not called we can use the default which is the common address > > for most at91 SOCs. > > It's a low level debug option, my understanding is that you only enable it > when one specific entry point fails to load on your board and you need some early > output to start debugging. > It shouldn't be kept on by default. Indeed only 6 defconfigs out of 126 ARM defconfigs > turn it on. (One of them my fresh microchip_ksz9477_evb_bootstrap_mmc_defconfig, oops..) I follow you here and see your point. Lets keep is as you did it. Sam _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
