sphinx warns:
Documentation/boards/imx/amazon-kindle-4-5.rst:39: WARNING: Enumerated list ends without a blank line; unexpected unindent.
Documentation/boards/imx/amazon-kindle-4-5.rst:42: WARNING: Enumerated list ends without a blank line; unexpected unindent.
Documentation/boards/imx/amazon-kindle-4-5.rst:45: WARNING: Enumerated list ends without a blank line; unexpected unindent.
Solve this by fixing the list enumeration and adding blank lines.
Signed-off-by: Roland Hieber <rhi@xxxxxxxxxxxxxx>
---
Documentation/boards/imx/amazon-kindle-4-5.rst | 6 ++++--
1 file changed, 4 insertions(+), 2 deletions(-)
diff --git a/Documentation/boards/imx/amazon-kindle-4-5.rst b/Documentation/boards/imx/amazon-kindle-4-5.rst
index 58f38a058e..26f072e28d 100644
--- a/Documentation/boards/imx/amazon-kindle-4-5.rst
+++ b/Documentation/boards/imx/amazon-kindle-4-5.rst
@@ -25,35 +25,37 @@ on iomux pullups may significantly reduce your standby-time.
Building barebox
----------------
``make kindle-mx50_defconfig`` should get you a working config.
Uploading barebox
-----------------
To upload and run a new bootloader, the older devices can be put into
USB bootloader mode by the SoC microcode:
1. Connect the Kindle to your host computer with a USB cable.
2. Power down the device by holding the power button until the power LED goes
dark (about 10 seconds).
-4. Hold the power button, and hold down a device-specific special key:
+3. Hold the power button, and hold down a device-specific special key:
+
* the fiveway down button on the model D01100
* the home button on model D01200
+
4. Then release the power button, but still hold the special key.
5. A new USB device named ``NS Blank CODEX`` should appear on your host computer.
You can now release the special button.
-7. Finally, upload barebox to the Kindle by using:
+6. Finally, upload barebox to the Kindle by using:
.. code-block:: console
$ scripts/imx/imx-usb-loader barebox-kindle-d01100.img
$ scripts/imx/imx-usb-loader barebox-kindle-d01200.img
Additionally, a USB serial ACM console will be launched by a barebox init script
when:
* the cursor select key is pressed during startup of model D01100
* the home button is pressed within a second after startup of model D01200.
(If you press the home button during startup, you will enter USB boot mode.)
* the EY21 has no keys to press, a USB console will be launched for 10s.
--
2.19.1
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
