Timeout of 1ms is too low for case when device operates in Full Speed mode. This causes most incoming frames to be lost. Since timeout is only used to get out of polling loop in case of no response from hardware, increasing it should be safe for all platforms. Signed-off-by: Nikita Yushchenko <nikita.yoush@xxxxxxxxxxxxxxxxxx> Tested-By: Andrew Lunn <andrew@xxxxxxx> --- drivers/net/usb/usbnet.c | 2 +- 1 file changed, 1 insertion(+), 1 deletion(-) diff --git a/drivers/net/usb/usbnet.c b/drivers/net/usb/usbnet.c index 33d900b70..60e67ff1a 100644 --- a/drivers/net/usb/usbnet.c +++ b/drivers/net/usb/usbnet.c @@ -125,7 +125,7 @@ static int usbnet_recv(struct eth_device *edev) len = dev->rx_urb_size; - ret = usb_bulk_msg(dev->udev, dev->in, rx_buf, len, &alen, 1); + ret = usb_bulk_msg(dev->udev, dev->in, rx_buf, len, &alen, 100); if (ret) return ret; -- 2.11.0 _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
