boot problem w/ barebox

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi folks,


I've got a really strange booting problem on an phycore-imx6
based board (pretty much the same as mira):

* barebox v2017.06.1-phy2 comes up properly, but cant boot
  the kernel (v4.13) - just hangs w/o any output (not even
  uncompression message)
* putting the kernel manually into the factory-image (sdcard)
  w/ old 2015 barebox boots the kernel
* w/ DEBUG_LL + earlyprintk it doesn't even does that, just
  hangs like w/ new barebox


Here's the last output I've got: (added few more debug outputs)

> Loading ARM Linux zImage '/mnt/mmc/boot/zImage'
> Loading devicetree from '/mnt/mmc/boot/imx6q-phytec-mira-rdk-emmc.dtb'
> Updating DT commandline: console=ttymxc1,115200n8 root=/dev/mmcblk0p2 rootwait rw earlyprintk=1 > DT commandline: console=ttymxc1,115200n8 root=/dev/mmcblk0p2 rootwait rw earlyprintk=1
> booting kernel with devicetree
> start_linux: kernel entry point: 12000000
>                            dtb: 18000000
>                           swap: 0
>                           arch: 0
> shutting down barebox

My first suspicion was zero'ed DT memory node (which OTOH doesn't
explain why earlyprintk doesn't work), but fixing that didn't help.

Could there be any vital low-level init missing in the new bbx ?
Maybe the entry point correct ?

Any ideas where I could have a deeper look at ?


thx.

--mtx

--

mit freundlichen Grüßen
--
Enrico, Sohn von Wilfried, a.d.F. Weigelt,
metux IT consulting
+49-151-27565287

_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox




[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux