Hi Lucas. > > Just to let you know the current status here: While I think you are on > the right track with this, I'm currently lacking the bandwidth to > properly review this series. I'm a bit hesitant to just throw it into > -next without any kind of review, so I'm still hoping for others to take > a look. Thanks for the heads-up. Review is a must as I am in unknown land here. The most important part is if the apporach is correct or not. I have continued with the effort to DT enable the at91sam9263ek board and have a barebox that boots using DT now with most stuff working. atmel_lcdfb did not support DT which I have added. All other drivers worked more or less out-of-the-box. In the process there have been a few cleanups and fixes and I will post the patches after some more testing. Not everything is working yet: - the NAND cannot read BBT (NAND is properly identified) - environment load /dev/env0 fails (maybe related to the above) - no kernel booted yet - bootstrap not tested (will provide a defconfig if I get it working) - network is not yet tested I expect to work on the above list and hold back patches until everything is working. That will take a few days. If everything goes like for the other challenges I will run to the other side of the forest to pick up a small splinter of wood in my effort to find a fix. Which is OK as this is part of the fun :-) Sam _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox