Hi Sam, Am Freitag, den 07.07.2017, 14:10 +0200 schrieb Sam Ravnborg: > The following patchset moves the reset vector > for at91 boards from mach-at91 to board code. > This is similar to what other boards do and is done to > prepare for multi-image and DT support. > > The patchset convert all boards and thus clean up the > old code that resided in mach-at91/ > > The first patch have minimal impact, but prepares for a > board-by-board conversion. > All temporary CONFIG symbols are gone at the end of this series. > > I kept Jean-Christophe PLAGNIOL-VILLARD and others > copyright in all the created files and did not add > copyright myself. The patchset does IMO not add any > copyrightable material from my side as this is > in reality just moving around code. > > The patchset was successfully booted on a AT91SAM9263EK, > and all defconfigs was built (expect the ones that failed > to build before this patchset was applied). > > Changes v1 => v2 > - converted all boards over > - fixed author info Just to let you know the current status here: While I think you are on the right track with this, I'm currently lacking the bandwidth to properly review this series. I'm a bit hesitant to just throw it into -next without any kind of review, so I'm still hoping for others to take a look. Regards, Lucas _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
