Hi all. I recently purchased an AT91SAM9263-EK from ebay and have played around a little with barebox. For now only some observations. I had the impression that I could drop AT91BootStrap when using barebox. But I could not make it boot until I deployed at91bootstrap (named BOOT.BIN) on the SD-card. And I named arch/arm/pbl/zbarebox.bin => u-boot.bin on the SD-card. I wanted to boot barebox - but nothing happened. So I tried older versions af barebox: v2017.06.0 => Boots OK (did not try to load a kernel) v2017.07.0 => Boots but emits: NULL pointer dereference at address 0x00000014 ### Please RESET the board ### (A bit more was written to the serial console) master from git => Nothing written to the console at all I will as time permits dig deeper into this. Seems like we are facing two bugs: One that causes the NULL pointer, and another that prevents any output. As barebox is quick to build and the bug is simple to spot I will likely just try to bisect and see where I end up. Sam _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
