On Fri, Jun 09, 2017 at 09:25:56AM +0200, gianluca wrote: > > > > > > > > imx-esdhc 2194000.usdhc: registered as 2194000.usdhc > > > > imx-esdhc 2198000.usdhc: registered as 2198000.usdhc > > > > imx-esdhc 219c000.usdhc: registered as 219c000.usdhc > > > > imx-ipuv3 2400000.ipu: IPUv3H probed > > > > netconsole: registered as netconsole-1 > > > > malloc space: 0x2ff7b920 -> 0x4fef723f (size 511.5 MiB) > > > > environment load /dev/env0: No such file or directory > > > > Maybe you have to create the partition. > > > > running /env/bin/init... > > > > Running boot from uSD/MMC or USB... > > > > mmc2: detected SD card version 2.0 > > > > mmc2: registered mmc2 > > > > ext4 ext40: EXT2 rev 1, inode_size 128 > > > > mmc2 is detected and registered because you are booting from it, but > > mmc3 is not. Try 'detect mmc3' or 'detect -a' on the command line. > > > > It was missing a mmc3.probe=1 in the init scripts. Now both are recognized > correctly. Try 'mount mmc3.0' without any further arguments. No need to probe manually then. Also my usual three words: Use bootloader spec. No need to write any init or boot scripts then. barebox will just work without any further configuration. > > Now I am trying to extend the I2C Lines outside the board for a oscilloscope > and/or a Saleae Logic Bus Analyzer. As soon as I find the solution or not I > will keep you informed. > > Anyway in the config there is both GPIO BASED I2C DRIVER and Platform iMX > Driver. I tried to disable the GPIO Based but it does not work. The GPIO I2C driver is only used when it's there's a GPIO I2C device registered in the device tree. Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox
