On Fri, May 12, 2017 at 01:07:19PM +0200, Daniel Schultz wrote: > The Beaglebone environment should be set from outside with an application > specific environment. > > Signed-off-by: Daniel Schultz <d.schultz@xxxxxxxxx> > --- > arch/arm/boards/beaglebone/Makefile | 1 - > arch/arm/boards/beaglebone/board.c | 2 -- > arch/arm/boards/beaglebone/defaultenv-beaglebone/boot/sd | 6 ------ > .../arm/boards/beaglebone/defaultenv-beaglebone/init/usb-limit-1300 | 5 ----- > 4 files changed, 14 deletions(-) > delete mode 100644 arch/arm/boards/beaglebone/defaultenv-beaglebone/boot/sd > delete mode 100644 arch/arm/boards/beaglebone/defaultenv-beaglebone/init/usb-limit-1300 > > --- a/arch/arm/boards/beaglebone/defaultenv-beaglebone/init/usb-limit-1300 > +++ /dev/null > @@ -1,5 +0,0 @@ > -#!/bin/sh > - > -echo -n "changing USB current limit to 1300 mA... " > -i2c_write -b 0 -a 0x24 -r 0x01 0x3e > -echo "done" We need this on the beagleboard. We can't just delete it without doing this somewhere else. Also I still do not understand the reasoning behind this change. Where is "outside", to which application should the environment be specific to? Sascha -- Pengutronix e.K. | | Industrial Linux Solutions | http://www.pengutronix.de/ | Peiner Str. 6-8, 31137 Hildesheim, Germany | Phone: +49-5121-206917-0 | Amtsgericht Hildesheim, HRA 2686 | Fax: +49-5121-206917-5555 | _______________________________________________ barebox mailing list barebox@xxxxxxxxxxxxxxxxxxx http://lists.infradead.org/mailman/listinfo/barebox