Re: [PATCH] mtd: nand_mxs: fix NAND error when change clk rate

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



Hi Christian.

On Wed, Dec 21, 2016 at 10:38:41PM +0100, Christian Hemp wrote:
> The function "nand_enable_edo_mode" changed the NAND clk rate, without turning
> it off. In this case it is posible to get the following errors:
>     MXS NAND: Error sending command
>     MXS NAND: Error sending command
>     MXS NAND: DMA read error
> 
> This can be fixed if the NAND clk is disabled before we change the clk
> rate.
Very interesting.
I have ~50 targets and a few of these are used for power cycle tests.
On one of these targets I have seen this exact same pattern - once...

Can you give any hints that makes it simpler to verify your fix or anything?


This is a board with i.MX6 SoloCore - where we have 2 GiB FLASH + 512 MB RAM.

Anyway - it saved my day to see this landing on the mailing list!

	Sam

_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox



[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux