Re: [PATCH 00/17] RFC for additional 'nvmem' plumbing

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

 



On Tue, Feb 16, 2016 at 7:09 PM, Trent Piepho <tpiepho@xxxxxxxxxxxxxx> wrote:
> On Tue, 2016-02-16 at 17:29 -0800, Andrey Smirnov wrote:
>> Hi everyone,
>>
>> The main purpose of this patchset is propose additional Nvmem plubing
>> needed for that subsytem's inclusion in BB and solicit feedback about
>> it (patches ## 15 to 17) . Included in this set are also a number of
>> bugfixes and RFC-for-bugfixes for problems that were discoverd during
>> development of this patch series.
>>
>> Proposed Nvmem additions are two new platform device drivers that
>> implement a nvmem interface on top of data embedded in DT as well as
>> nvmem interface that allows to combine existing nvmem-accesible bytes
>> into continuous blocks.
>>
>> Below is an example of DT code that uses both drivers in order to
>> create a MAC address as a combination of bytes from DT and OCOTP
>> module:
>
> So for a common case Sasha has pointed out, of the MAC in the opposite
> byte order, one would write:
>
>         scatter-gather-blob {
>                 compatible = "barebox,nvmem-sg";
>                 #address-cells = <1>;
>                 #size-cells = <1>;
>
>                 mac_address: combined-bits {
>                         reg = <0 6>;
>                         layout = <&fec_mac_address 5 1
>                                   &fec_mac_address 4 1
>                                   &fec_mac_address 3 1
>                                   &fec_mac_address 2 1
>                                   &fec_mac_address 1 1
>                                   &fec_mac_address 0 1>;
>                 };
>         };
>
>         &ocotp {
>                 #address-cells = <1>;
>                 #size-cells = <1>;
>
>                 fec_mac_address: mac_address@88 {
>                         reg = <0x88 0x8>;
>                 };
>         };
>
>         &fec {
>                 ?mac-address-location?? = <&mac_address>;
>         };
>

mac_address is still a nvmem cell, so the DT code for FEC would remain the same:

&fec {
    nvmem-cells = <&mac_address>;
    nvmem-cell-names = "mac-address";
}


> I suppose that's a very powerful system, but it does seem a bit
> cumbersome.

I agree, those bindings don't really make me glow with pride because
of their elegance, but unfortunately I wasn't able to come up with
anything better that would be as generic and not tied into a
particular use case of MAC address manipulation.

_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox



[Index of Archives]     [Linux Embedded]     [Linux USB Devel]     [Linux Audio Users]     [Yosemite News]     [Linux Kernel]     [Linux SCSI]     [XFree86]

  Powered by Linux