Avoids a build failure if the config does not include ULPI support.
This is similar to what has been done to the PCA100 board.
Signed-off-by: Lucas Stach <l.stach@xxxxxxxxxxxxxx>
---
arch/arm/boards/guf-neso/board.c | 9 +++++----
1 file changed, 5 insertions(+), 4 deletions(-)
diff --git a/arch/arm/boards/guf-neso/board.c b/arch/arm/boards/guf-neso/board.c
index 67fd50849d5f..f40f0d15914d 100644
--- a/arch/arm/boards/guf-neso/board.c
+++ b/arch/arm/boards/guf-neso/board.c
@@ -110,7 +110,7 @@ static struct imx_fb_platform_data neso_fb_data = {
.framebuffer_ovl = (void *)0xa7f00000,
};
-#ifdef CONFIG_USB
+#if defined(CONFIG_USB) && defined(CONFIG_USB_ULPI)
static void neso_usbh_init(void)
{
uint32_t temp;
@@ -130,7 +130,11 @@ static void neso_usbh_init(void)
gpio_set_value(USBH2_PHY_CS_GPIO, 0);
mdelay(10);
ulpi_setup((void *)(MX27_USB_OTG_BASE_ADDR + 0x570), 1);
+ add_generic_usb_ehci_device(DEVICE_ID_DYNAMIC,
+ MX27_USB_OTG_BASE_ADDR + 0x400, NULL);
}
+#else
+static void neso_usbh_init(void) { }
#endif
static int neso_devices_init(void)
@@ -266,10 +270,7 @@ static int neso_devices_init(void)
imx27_add_nand(&nand_info);
imx27_add_fb(&neso_fb_data);
-#ifdef CONFIG_USB
neso_usbh_init();
- add_generic_usb_ehci_device(DEVICE_ID_DYNAMIC, MX27_USB_OTG_BASE_ADDR + 0x400, NULL);
-#endif
imx27_add_fec(&fec_info);
--
2.1.4
_______________________________________________
barebox mailing list
barebox@xxxxxxxxxxxxxxxxxxx
http://lists.infradead.org/mailman/listinfo/barebox
